Halloween Necklace

Materials:

Instructions:

Flatten and cut white Model Magic® Fusion® into the size and shape of a ghost pendant. To make a reclining figure like the one shown, create a long ghost with a bottom that comes to a gradual point. Roll this point around your finger so the necklace yarn can pass through the spiral.
Bend the hands to hold the pumpkin and necklace.
Shape and decorate a tiny pumpkin. Attach to the right hand of the ghost, as shown.
Add ghost eyes and mouth with dots of glitter paint. When dry, brush a thin layer of glitter paint over the ghost. Let dry.
Thread the yarn through the bottom of the ghost, around the back, and through the left arm. Reinforce any pieces with glue.

Halloween Candy Wrapper/Gift

Materials:

Instructions:

Cut black cardstock to fit around candy bar. Cardstock should overlap about 1-inch. Glue cardstock to candy bar wrapper.
Cut orange cardstock to 1½-inches x 5-inches or larger if needed. Glue to front of wrapper.
Draw bat on black cardstock and cut out. Glue bat to orange cardstock.
Cut one 1-inch x 2¾-inch orange rectangle. Cut one ¾-inch x 2½-inch white rectangle. Write Happy Halloween on the white rectangle and glue to the orange rectangle.
Punch a hole in tag and through black cardstock. Thread raffia through both holes. Tie and trim raffia ends. Use glue to keep tag in place.

Materials:

Instructions:

Materials:

Instructions:

Sand photo stand until smooth. Wipe dust off with damp paper towel.
Cut two small pieces of painter’s tape and wrap around base of wire photo holders.
Paint photo stand and two roundhead plugs with two coats of Bright Blue, allowing paint to dry between coats. Peel off painter’s tape.
Tape off lines as shown and paint two coats of Citron Green, allowing paint to dry between coats. Remove tape.
Glue wiggle eye to top portion of block. Glue roundhead plugs to sides of block.
Draw a smile lightly with pencil. Trace over with black marker.
Cut out small foam squares for teeth and attach to face.
Cut a 3-inch length of green boa and attach around the bases of the wire photo holders with glue.

Materials Needed:

Instructions:

Cut an orange piece of foam into 1” strips lengthwise. Set aside.
Cut the black foam sheet into 1” strips width-wise (top to bottom). Lay the vertical strips side by side in front of you. Weave an orange strip horizontally through at the top of the black strips, and glue them all together. Allow to dry.
Repeat step 2 until all the orange strips are in place. Apply glue only at the beginning and end of each strip. The final strip gets glued along the entire outside edge.
Repeat steps 1 through 3 with the other colors of foam sheets. Be sure to always cut the orange sheets lengthwise, and the contrast color vertically.
Trace 4 of each bone onto the white foam sheets, and cut out.
Glue bone pieces onto placemats as seen in photo. They will go where the fork, knife and spoon go.