Use Fimo dough of your choice and make a disk. Use a straw to cut a hole for the ribbon to attach to it. Press the key into the Fimo dough to make a good imprint. Bake as directed. Write sentiments on the side. If you would like, wash the key and dry – then glue into the imprint. Makes great little keepsakes when you move.
A stunning wall decoration created by molding and layering simple template
shapes combined with surface texturing techniques. The earthy yellow, red
and greens blend do well together to produce a strikingly authentic effect
YOU WILL NEED
1 batch salt dough
5-inch diameter saucer to use as a mold
Plastic food wrap
Fine srade sandpaper
synthetic sponge (optional)
Satin polyurethane varnish
~ Roll out the dough to a thickness of 1/4 inch on a lightly floured pastry board. Trace off the basic template, and then trace off the other template details following the solid lines (the dotted lines represent surface details). Cut out the templates in plain paper and place on the rolled-out dough. Cut around each shape, using a small knife, removing the eye and mouth sections. Remove the excess dough.
~ Cover the convex side of the saucer with plastic food wrap and lay it on the pastry board. Carefully lift the main mask template and place it over the mold. The saucer should fit under the face part of the mask and the head-dress should lie flat on the board. Moisten the entire surface of the dough with water and carefully lay the other cutout shapes in position.
~ Use modeling tools or a wooden skewer to make the surface decorations, referring to the dotted lines on the template and to the photograph as a guide. Use a moistened modeling tool to smooth out the joins. The raised details on the forehead and earrings are made from small balls of dough squashed to make a flatter shape and then pierced with the blunt end of a skewer. For the nose, model a small ball of dough into a pyramid shape and press it carefully into position, smoothing out the joins with a moistened modeling tool. Form the nostrils, using a pointed modeling tool.
~ Transfer the mask to the microwave turntable plate and bake on low for 20 minutes + 20 minutes, medium low for 20 minutes, and medium for 10 minutes + 10 minutes. Remove it from the microwave oven and leave to cool. Do not attempt to remove the mold while the dough is still warm as this may cause warping and damage. Gently prize the dough mask away from the mold and, using sandpaper, smooth off any rough edges.
~ Apply two coats of beige acrylic paint to both sides of the mask to act as a sealant and bottom coat. Apply the other decorative colors, using the photograph as a guide. Use a dry brush or a sponge to achieve the subtle effects.